Installed by people who can also fix the cabinet
Every appliance we install comes with the carpentry to make it fit — so a tight opening or an out-of-square cabinet never turns into a second trip or a damaged kitchen.
- Install + carpentry, one visit
- Standard to high-end
- Surfaces protected
Pick the appliance — we handle the fit
From a quick dishwasher swap to an integrated panel-ready column, each service includes measuring against the spec and modifying the cabinet when the opening needs it.
Dishwasher Installation
A dishwasher that's level, leak-checked, and secured to the counter — and if the bay is too wide or too tight, we close the gap or trim it on the same visit.
Learn more
Range & Cooktop Installation
We set slide-in ranges and drop-in cooktops to the cutout spec — and when the opening or counter is fighting the unit, we adjust the cabinetry on the same visit.
Learn more
Wall Oven Installation
We set single, double, and oven-microwave combo wall ovens at the manufacturer's mounting height, build the platform that actually carries the weight, and make the two-person lift so the unit seats flush and stays put.
Learn more
Refrigerator Installation
We install counter-depth, built-in, and panel-ready refrigerators — and when the cavity is the wrong size, we modify the surround so the unit sits flush, level, and even.
Learn more
Range Hood & Venting
We mount the hood, run the duct through the cabinetry, and do the surround carpentry so the insert sits flush at the right height and the venting actually pulls air outside.
Learn more
Microwave Installation
Built-ins with trim kits, drawers in base cabinets and islands, or over-the-range units — installed level, vented right, and cut into the cabinet so the reveal is even.
Learn more
Panel-Ready & Built-In
Integrated and panel-ready appliances live or die by their reveals — we hang the overlay panels, set the unit, and adjust the cabinetry so every gap stays tight and even.
Learn more
Cabinet Modification
When an opening is a half-inch too tight or a face frame is in the way, we modify the cabinet so the appliance fits — square, level, and damage-free.
Learn moreMost installers stop where the carpentry starts
Delivery crews set the box and leave. Carpenters build but don't wire and plumb. When an appliance doesn't fit, you're left coordinating two trades and a return trip. We close that gap: appliance installation and cabinet modification handled together, by the same hands, on the same visit.
See how cabinet modification worksThe same careful path on every job
- 01
Assess & measure
We start with the appliance spec sheet and the opening it has to live in — width, depth, height, the face frame, utilities, and the cabinet around it. Most fit problems are decided here, before a single tool comes out.
- 02
Protect the kitchen
Floors, countertops, and finished cabinet faces get covered, padded, and taped off first. Blue tape on the edges, moving blankets and ram board on the floor, and a vacuum staged for dust control.
- 03
Install & fit the cabinet
We set the appliance — and when it does not drop in clean, we modify the cabinet to make it: resizing the opening, building a support platform, adding filler strips, or aligning panels and trim for an even reveal.
- 04
Level, test & clean
The appliance is leveled, secured, and anti-tip hardware set where it belongs. We test operation, check every reveal and gap, then vacuum and wipe down so the kitchen is ready to use.
Get your appliance opening checked before delivery day
Send the appliance specs and a couple of photos of the space. We confirm the fit, flag any cabinet work, and give you a clear plan — no guesswork on install day.